Page 1
This document is protected by copyright law. Unauthorized duplication, display, or modification in any form is prohibited. This document applies only to the software/hardware indicated. Due to continuing development, the information is subject to change without notice. This document contains no guarantees or warranties specifically expressed or implied. Fiber Optic Communications MC210CS Document: CS-0059-01...
FIBER OPTIC CONVERTER INSTALLATION CONNECTION AT THE BUILDING/OFFICE NOTE: Verify the software type configured with your display. If you are using a custom or 3rd party option, contact Locate the Fiber Optic adapter for the building. Install Plug in the other end of your Fiber Cables to the TX and RX near your computer or network connection and power on.
Page 3
SM Infinity - COMMUNICATIONS LightSpeed (SignScheduler) - COMMUNICATIONS The display needs to connect to SM Infinity in order to modify content and updates. Unless the display The display is managed by a computer connected directly to the shipped with a Cellular Modem, the display will use your local network to connect to SM Infinity online. WARNING: If you are unfamiliar with Network display, or over a network.
Page 4
MANUAL IP CONFIGURATION - CONFIGURE YOUR IP ADDRESS MANUAL IP CONFIGURATION - CONFIGURE THE SIGN’S IP ADDRESS NOTE: The instructions below assume you want to have your computer connected to both the display and your network/internet. The Sign Controller must be on the same IP scheme as the network to connect to Double-Click on Internet Protocol Version 4 your computer (LightSpeed) or the internet (SM Infinity).