3branch magstak Assembly Instructions

magstak™ quad tower display
assembly instructions
1
Remove items from packaging and check packing slip for
proper content and quantity.
magstak™ module
(quantities vary)
quad tower base
2
Tightly screw adjustable levelers into bottom of quad tower base
before assembling.
Safety Warning: Tower bases
are heavy! Use two people
when installing levelers into
bottom of base.
©3branch All Rights Reserved.
3branch.com
Sept 2023
optional
2-sided sign
(2 pieces)
adjustable
levelers (4)
optional
4-sided sign (2 pieces)
3
Stack one magstak™ module on top of the spinner base
using the alignment disks that set into alignment ports
as shown below.
detail 1
connector bolt
connector bolt
module
black spinner
base
4
Optional: connect bottom module to spinner base
using connector bolts (see detail 1). Stack second
module in same fashion and connect the two modules
using the binding post, neoprene washer and binding
screw (see detail 2) to ensure a secure and stable fit.
Do not over tighten!
completed tower
NOTE: Towers with standard size modules
are 6 modules high. Towers with tall
modules are 5 modules high (pictured).
Towers with magazine modules are 4
modules high. Signage is optional.
See care instructions for proper care and
handling of product.
5
See optional magstak™ signage assembly instruction
on reverse/page 2.
detail 2
binding post
binding post
module
module
neoprene washer
binding post screw
877.899.9902