Epic Office Furniture Agile+ Desk Instructions

Agile+ Desk

Handset instructions

To use the handset, press either the UP or DOWN keys and the display screen will light up to confirm the
handset is ready for use. If there is no button pressed within 30 seconds, the screen turns off and the
M1/M2/M3/M4 keys are disabled accordingly.

Display Screen

Displays the height of the desk
Up & Down Keys
Press the " " or "

Memory Key M1/M2/M3/M4

Raise or lower the desk to the desired height and hold one of the M1/M2/M3/M4 keys for around 5 seconds,
until the "beep", and the height will be successfully saved.
When the desk is ready for use, press M1/M2/M3/M4 and the desk will move to the saved height automatically.

Locking the Handset

To lock the handset, when the handset is ready for use, press both the "
until the display shows "LOC". To unlock the desk, when the handset is ready for use, press both the DOWN and
M4 keys for around 5 seconds until the display returns to the height number.

Resetting the Desk

1. When "RST"
After desk frame rebounds slightly, you will hear a "beep" and the desk will be reset.
(The button cannot be released during this operation, otherwise the reset will fail).
2. Forced Reset: Press the "
and press it again for about 5 seconds until desk frame rebounds you hear a "beep".
3. Restore the factory settings: When new controller is changed, or the settings need to be restored
to the factory defaults, press the "
about 5 seconds and a second "beep" after 10 seconds. Once the display screen shows "RST", complete
a 'Forced Reset'.

Anti-Collision

When the desktop is raising or lowering, if it encounters resistance the desk will rebound and show "E05".
Wait for the height number to return and check for any obstacles.

Handset shows error code and solution

" key to adjust desk height until you get an optimum height
is on the display screen, press the "
" button until the desk frame reaches its lowest point, then release the button
" and " " buttons simultaneously, you will hear the first beep after
Power fault Power off for 30 seconds and restart
Handset fault Unplug and replug the cable of hand set and reset the desk
Anticollision alert Rebound reminder, check for obstacles and reset
Desktop sloping Reset the desk
Connection cable failure Check the connecting cable between motor and control box
Controller fault Exchange the controller
Motor fault Change motor
Overloading Reduce the weight on desk and reset
Overtime operation Automatic recovery after 20 minutes
Press the down arrow until the desk reaches it's lowest
Reset reminder
height until the numbers reappear
" and M4 keys for around 5 seconds
" button until the desk frame reaches its lowest point.