Cleaning The Water Tank; Self-Cleaning Mode - smartmi Evaporative Humidifier 3 User Manual

Cleaning the water tank

To prevent contamination and odor in water tank, rinse
with clean water or wipe with a soft cloth.
There are drainage holes at the bottom of the water tank.
Do not use the water tank straight away after it has been
fully rinsed or after adding too much water by accident.
Instead, place the water tank on the ground with the
drainage holes facing down to drain the water from inside
the tank.
Drainage hole
Note: Do not immerse water tank. During the cleaning process, cover the
power port with rubber plug to keep water out.
Air-drying mode
For low water levels with Air-drying mode enabled,
humidifier air dries water tank to avoid contamination and
odor and then automatically shuts down.
Tip: Enable/disable Air-drying mode via "Mi Home / Xiaomi Home" app.

Self-cleaning mode

Enable Self-cleaning mode via "Mi Home / Xiaomi Home"
app. After enabling, humidity indicator on display scrolls
in rotation, air outlet stops blowing, evaporator continues
rotating in water tank to soak and clean evaporator and
eliminate odors. Reminder is displayed on App after 30
minutes, and the device automatically shuts down with a
beep.
Disable Self-cleaning mode via "Mi Home / Xiaomi Home"
app or briefly press "On/Standby" button to end self-
cleaning.
Note:
1. To avoid deforming the evaporator, avoid using water above 35 °C to
clean the humidifier.
2. To avoid corrosion or chemical burns to water tank and/or evaporator,
do not use acid, alkali, or corrosive detergents for cleaning.
09