Troubleshooting - E-MORE TV LIFT 650 Assembly Instructions Manual

ATTENTION!
DO NOT install upside down. (e. g. installation on the ceiling) It will cause damage to the product and TV.
SAFETY AND WARNING!
This product can be used by children age 8 years and older, a persons with reduced physical, sensory or mental capacity as
long as they have been given proper instructions / training on how to use the product in a safe way and understand the haz-
ards involved. Children shall not play with the product.
REMOTE CONTROL REPLACEMENT
After replacing the remote control, linking of the 2 devices is necessary.
linking-process:
1. Disconnect the power of the TV mount.
2. Wait for approx. 15 seconds and reconnect the power of the TV mount.
3. Now press the Up-, Stop,- and then the Down-Button in succession.
4. You will hear a 1 second beeping sound, which signals the successful synchronisation.
The remote control is now ready to use.

TROUBLESHOOTING

Error Code Possible Cause
E01, E02 Cables are not connected or broken
the weight of the desk exceeds 60/80 kg
E07 Load weight exceeds 60/80 kg
E08 Input voltage lower than required
E09 Input voltage higher than allowed
Control panel is not connected or does not
E10
receive power
RES
Reset is required
Excessive use
HOT
CORRECT DISPOSAL
This sign indicates that this product must not be disposed through regular household waste within the European
Union. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased. There you can obtain all
information necessary to dispose of this product properly. (WEEE-Reg.-Nr. DE: 52242201)
E-MORE TV LIFT 650 / 1000
How To Correct
Connect cables properly, if problem persists change engine
Remove weight
Remove weight
Improve the input voltage
Lower the input voltage
Wait 1 second for the error code to disappear
If it persists check the connection cables
Hold the "Down"-Button for a while . The mount will lower to the
minimum height .
Do not use for 18 minutes . System will recover automatically .
11