ledscom LC-EL-153-WW Assembly Instructions Manual page 5

Before first use, charge the light for at least
8 hours in clear sunlight.
This is a solar powered light.
Install the luminaire in a place which
receives a lot of sunlight to ensure good
operation of the luminaire.
Do not place the luminaire near other light
sources, as this luminaire switches the light
via a day/night sensor. If the ambient
brightness is too high, the light will not turn
on.
Contamination on the light can also
negatively affect the charging capability of
the light. Therefore, clean the light when
necessary.
The luminaire automatically detects the
ambient brightness. It will turn off when
bright and turn on automatically when dark.
You can switch luminaire on or off
permanently using the slide switch located
on the back of the luminaire. Regardless of
the position of the switch, the solar cells
charge the battery until it is fully charged.
Low battery level:
When the battery level is low, the
brightness of the light is automatically
reduced.
Battery protection:
When the battery level is extremely low,
the light goes into battery protection mode
and turns off the light.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Paving stone (LC-EL-153-WW) - Assembly instructions
05/2023