Table of Contents
Advertisement
Deck Wash System™
•
Use the Deck Wash System™ to rinse grass clippings
from the deck's underside and prevent the buildup of
corrosive chemicals. Complete the following steps after
each mowing:
Make certain the tractor's discharge chute is
IMPORTANT:
directed away from your house, garage, parked cars, etc.
1. Drive the tractor to a level, clear spot on your lawn, near
enough to a water sillcock (spigot) for your garden hose
to reach.
2. Move PTO to "BLade Stop" position.
3. Set the parking brake and stop engine.
4. Thread hose coupler (packaged with this manual) onto
the end of your garden hose. See Figure 11.
5. Attach the hose coupler to the water port on your decks
surface. See Figure 11. Turn the water on.
6. While sitting in the operator's position, re-start the engine and place throttle lever in FAST (rabbit) position.
7. Move the PTO lever to ON position.
8. Remain in the operator's position with the cutting deck engaged for a minimum of two minutes and allow the
underside of the cutting deck to throughly rinse out.
9. Move the PTO lever to the "Blade Stop" position.
10. Turn the ignition key to the STOP position to turn the tractor's engine off.
11. Turn the water off and detach the hose coupler from the water port on your decks surface.
Water Port
17
Hose Coupler
(Shown without
Hose Attached)
Figure 11
Advertisement
Table of Contents
