Download Print this page

CAS DataLoggers DT80 Quick Start Manual

Connecting a dataTaker DT80 Range Data Logger to an Ethernet Modem

How to Enable Remote Data Transfer

CHESTERLAND, OH—December 28, 2015

1. Prerequisites:



Nil



dataTaker DT80 range data logger



Ethernet modem



Crossover Ethernet cable



Active SIM card

1. Insert the SIM card into your modem

2. Following the guide supplied with your modem, apply

the necessary settings to automatically connect to the

mobile network. Also note down any settings that relate

to TCP/IP

3. Connect the antenna to your modem

4. Apply power to the dataTaker

5. Plug one end of the Ethernet cable into the

dataTaker and the other end into the Ethernet

modem (see Figure 1 below). Ensure the plugs

'click' when connected

Table of Contents

Do you have a question about the DT80 and is the answer not in the manual?

Page 1 Connecting a dataTaker DT80 Range Data Logger to an Ethernet Modem How to Enable Remote Data Transfer CHESTERLAND, OH—December 28, 2015 1. Prerequisites:  2. Required Equipment:  dataTaker DT80 range data logger  Ethernet modem  Crossover Ethernet cable ...
Page 2 Figure 1 - Ethernet connection to the dataTaker and a Call Direct modem 6. Connect the power to the modem, wait for it to power up 7. Now that the two devices are connected and powered, to ensure that they can talk over the Ethernet cable, they must have their TCP/IP settings configured a.
Page 3 Eth IP: Auto 192.168.1.51 Figure 2—‘Eth IP’ sample screen (Auto) NOTE: If the IP address begins with ‘169.254’ then the logger has assigned itself an IP, not the server. In this case a static IP address must be used. 3.2.2 Static IP Addresses: To assign a static IP address you will need to follow these steps: 1.
Page 4 CAS Data Logger Applications Specialist at (800) 956-4437 or visit our website at www.DataLoggerInc.com. Contact Information: CAS DataLoggers, Inc. 8437 Mayfield Rd. Chesterland, Ohio 44026 (440) 729-2570 (800) 956-4437 sales@dataloggerinc.com...