Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the wash
cycle.
Cause and Troubleshooting
Unauthorized extension fitted to the water drain
hose.
Remove unauthorized extensions to the water drain
▶
hose.
→
"Connecting the device", page 15
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The handle of the pump
cover must be vertical.
was not pressed.
Press .
▶
The strainers in the water supply are clogged.
▶ Clean the strainers in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or trapped.
The imbalance control system removes the imbalance
by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
The program sequence is optimized electronically. This
may lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system removes the imbalance
by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
Foam control system performs an extra rinse in case
of excessive foam formation.
No error - no action required.
▶
TroubleshootingNL
49