Cleaning The Spray Arms - Atag DW8214MB Manual

NOTE!
Dishwashing results may be affected if the coarse and fine filters are incorrectly fitted. The
dishwasher must not be used without the filters in place!

Cleaning the spray arms

Holes and bearings can sometimes become blocked. Remove any debris using a pin or the like.
The spray arms also have holes underneath.
To facilitate cleaning you can remove the spray arms. Remember to fit them firmly back into place
afterwards.
Top spray arm
Pull out the top cutlery tray. Push up on the top spray arm while turning it anticlockwise to release
it.
Upper spray arm
Pull out the upper basket.
Check that the yellow
drainage pump stop (on the
right in the bottom drain) is in
place.
Care and cleaning
27