X-Sense WS01 - Water Leak Sensor Manual

lntroduction

This water leak sensor sounds an alarm whenever it comes into contact with water. lt can Ье placed near common household water sources like а dishwasher, hot water heater, or washing machine. With professional monitoring, you will Ье notified if your home is in danger.

Product Overview

Package Contents

Operating Your Device

Activating the Device

Press and hold the Activate button for 3 seconds. When the red LED flashes once and the alarm sounds one Ьеер, then the product is activated and enters the normal working status.

Testing the Device

After the device is activated, you must test the device to ensure it is operating normally. Press the Test button at the bottom of the device. The alarm will deliver 3 beeps paired with the red LED flashing. The sound will automatically stop after the test is completed.

Water Leak Detection

This water leak sensor is used to detect water leaks and floods. Once а water leak occurs, the device will sound an alarm continuously paired with а flashing red LED. lf the user takes no action at this time, the device will continue to sound an alarm until the battery runs out.

Silencing the Device

When the device is triggered, press the Silence button to mute the alarm, which will last for 1 О seconds. After 1 О seconds, the device will continue to sound an alarm. То disaЫe the alarm, you must completely clean and dry the surface of the device.

lnstalling Your Device

lnstallation Location

You can use the device near places where water leaks are likely to occur such as near water pipes, basement sump pumps, dishwashers, washing machines, toilets, water heaters, window wells, etc.

lnstallation Method

This sensor can simply Ье placed on а flat surface.

Note

1. Do not рlасе the device upright, otherwise по alarm will Ье triggered.
2. Do not рlасе the device оп uneven surfaces as this mау cause false alarms.
   

Battery Replacement

When the battery is low, the red LED will flash once every 60 seconds paired with one Ьеер to remind the user to replace the batteries. То replace the batteries, remove all screws, take out the used batteries and replace with two new ААА batteries. Then, reinstall the screws and press and hold the Activate button for 3 seconds to activate the device. Then test the device once again.

Note: After rep/acing the battery, уои need to align the positioning points of the upper and lower cases to close the cover and then screw the device closed.

1. Кеер the device operating at а temperature between 32-122°F (О-50°С) and humidity below 90% RH.
2. Do not disassemЫe the device Ьу force. Otherwise, the device may become damaged.

Technical Specifications

Troubleshooting