Childproof Lock; Finishing By Canceling The Programme; End Of Programme - Blomberg TKF 7231 Manual

Table of Contents

Advertisement

Available languages

Available languages

turning the programme selection knob. Only
the drying light turns on and the machine
remains in hold until a new programme is
selected and the "Start/Pause/Cancel" button
is pressed. Child-proof lock of the machine
should not be active in order to perform
these two operations. If the child-proof lock is
active, deactivate it before performing these
operations.
Adding/removing laundry in standby mode
In order to add or remove laundry after the
programme starts:
1. Press the "Start/Pause/Cancel" button to
switch the dryer to "Pause" mode. Drying
process will stop.
2. Open the door at "Pause" position and
close it again after adding or taking out
laundry.
3. Press "Start/Pause/Cancel" button to start
the programme.
C
Any laundry added after the drying process
has started may cause the dried clothes in
the machine intermingle with wet clothes
and the result will be wet laundry after the
drying process is over.
C
Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing
of button while the programme is running.
The loading door and all buttons except the
"On/Off" button on the control panel are
deactivated when the child-proof lock is active.
Press the "Start/Pause/Cancel" and "Cancel
audio warning" buttons simultaneously for 3
seconds to activate the child-press lock.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should be
deactivated. Press the same buttons for 3 sec.
again to deactivate the child-proof lock.
C
Child-proof lock is deactivated when the
machine is restarted by pressing the On/Off
button.
C
Press the relevant buttons for 3 seconds to
activate the child-proof lock. A long beep
will be heard and the child-proof lock will
be activated. A double beep will be heard if
you press any button or turn the programme
selection knob while the child-proof lock is
active. Press the buttons for 3 seconds to
deactivate the child-proof lock. Single beep
will be heard and child-proof lock will be
deactivated.
A
A double beep will be heard if you turn
the programme selection knob when the
machine is running and the child-proof lock
is active. If you deactivate the child-proof
lock without returning the program selection
knob to its previous position, the programme
will be terminated since the position of the
programme selection knob is changed. The
drying light turns on and the machine remains
on hold until a new programme is selected
and the "Start/Pause/Cancel" button is
pressed.

Finishing by canceling the programme

To cancel any selected programme:
Press "Start/Pause/Cancel" button for about
3 seconds. The "Filter cleaning", "Water tank"
and "End/ Anti-creasing" warning lights will
turn on at the end of this period for reminding
purposes.
A
As the inside of the dryer will be excessively
hot when you cancel the programme while
the dryer is running, activate the ventilation
programme to cool it down.

End of programme

The "End/Anti-creasing", "Filter cleaning" and
"Water tank" warning lights on the programme
follow up indicator will turn on when the
programme comes to an end. The door can be
opened and the machine becomes ready for a
second cycle.
Press "On/Off" button to turn off the dryer.
C
Final step of the drying cycle (cooling step) is
performed without heat application in order to
keep the items at a temperature that would
not harm them.
C
A 2-hour anti creasing programme to prevent
laundry from creasing will be activated if
you do not take the laundry out after the
programme has come to an end.
C
If you will not take the laundry out immediately,
do not stop the dryer before the drying
process is complete.
C
Clean the filter after each drying (please see,
Filter cleaning).
C
Drain the water tank after each drying (please
see, Water tank)
49 EN

Advertisement

Table of Contents
loading

Table of Contents