Table of Contents
Advertisement
5
6.2.5 MECHANISM ADJUSTMENT
Tangential and Radial Height Coarse Adjustment
1
START
• Remove the 05SD Pickup Assy from the Traverse Mechanism Assy-S.
• Remove the joint and the joint spring of the 05SD Pickup Assy.
Note:
Before removing the flexible cable for the
pickup, soldering of the pickup circuit is
necessary.
For details, see "7.1.10 DISASSEMBLY".
• Pass through the guide shaft to a new 05SD Pickup Assy.
• Attach it to the Traverse Mechanism Assy-S.
• Put the joint between the Tangential (or Radial) adjustment screw and the mechanism base
and turn each screw to adjust the height.
(Refer to "6.2.1 ADJUSTMENT ITEMS AND LOCATION".)
• Attach the Traverse Mechanism Assy-S to the 05 LOADER Assy.
• Turn it over and attach the joint and the joint spring.
• Arrange the flexible cables.
(Refer to "7.1.10 DISASSEMBLY".)
5
6
Guide Shaft
XV-EV500
6
7
05SD Pickup Assy
Joint
Joint Spring
05SD Pickup Assy
Joint
7.5mm
Mechanism base
7
8
A
B
C
D
E
F
87
8
Advertisement
Table of Contents
