Advertisement
03
How to connect Power and IR cables
* IR cable is an optional and IR cable length
can be extended by a link cable.
*Link Cable Plug Spec : Ø3.5mm, 2Pole
4
Press the mode button
for about 5 seconds to
enter Soft AP mode.
Press the RESET button for
about 5 seconds to reset
registered ZigBee devices.
* Factory Reset : Press RESET
& MODE button together at
the same time for about 10
seconds (you can hear the
beep sound 2 times)
IR 2
Power(Micro USB)
IR 1
25mm
14mm
04
How to install
Ceiling mounting
Bracket
Screw Ø3 x L12
Rubber Foots
Point Bracket Body
Body
① Install the screws(Ø3x L12 3ea) on proper location where it sets.
② Assemble the "Deco Cover" on the device.
③ Connect the power and IR cable(Optional) in each port on the bottom
of the main unit through bracket.
④ Assemble the main unit and the bracket.
Power Cable
IR Cable
/
(Optional)
Deco Cover
5
Advertisement
