Huawei ETS2258 User Manual page 2

Fixed wireless terminal

Hide thumbs Also See for ETS2258:

Table of Contents

No part of this manual may be reproduced or transmitted in any form or by any

means without prior written consent of Huawei Technologies Co., Ltd.

Trademarks

And HUAWEI are trademarks of Huawei Technologies Co., Ltd. All other

trademarks and trade names mentioned in this manual are the property of their

respective holders.

Notice

The information in this manual is subject to change without notice. Every effort

has been made in the preparation of this manual to ensure accuracy of the contents,

but all statements, information, and recommendations in this manual do not

constitute the warranty of any kind, expressed or implied.

Output Power of the FWT: 250mW (24dBm)

The antenna characteristics: omni-2.15dBi-vertical-50W-or-TNC/MALE, or

TLB-450-2H Indoor Aerial Omni-oriental, Integral Antenna. Compliance

boundaries have been calculated to be 0.12m..

The antenna(s) used for this transmitter must be installed to provide a

separation distance of at least 10 cm from all persons.

Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not in-stalled and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

—Consult the dealer or an experienced radio/ TV technician for help.

Table of Contents