INSTALLATION INSTRUCTIONS
F
OR
This ice maker adapter kit (P/N 629085001) is for the following units:
Dispenser Model
ED200/250
Item No.
Part No.
1
620032802
2
22128
3
50904
4
620032804
5
70226
6
70188
7
620913501
!
WARNING:
Disconnect power to the unit before installing the adaptor following all lockout/tag out procedures established by the
user. Verify that all the power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
!
WARNING:
All ice baffle plates and bin stats, if included or recommended in this kit, must be installed as directed in this manual or
the equipment manufacturer's instructions.
Failure to comply could result in serious injury, death or damage to the equipment.
!
WARNING:
All of the attachment screws and plates must be installed as directed in this manual.
Failure to comply could result in serious injury, death or damage to the equipment.
Perform the following procedure to install the adapter kit.
1. Remove merchandiser from the dispenser by lifting up on both the right and the left sides to disengage the
merchandiser from slots in the dispenser cabinet. Tilt the merchandiser forward from the top and lift off.
NOTE: Disregard Step 2 if the ice diverter has been factory installed.
2. Refer to Figure 4 for the following:
A. Remove the ice chute cover (snap-fit) and ice chute (4 nuts).
B. Remove the gate restrictor and discard.
C. Install the ice diverter as shown.
D. Replace the ice chute and cover.
3. Refer to Figure 3 for adjusting the automatic agitation timer.
A. Loosen/rotate the center mounting screw that secures the white reflector panel/electrical control box
cover in place and lower the cover to expose the automatic agitation timer.
B. Adjust the timer to 2 seconds "ON" and 1 hour "OFF" as shown in Figure 3.
Release Date: November 10, 2010
© 1998-2010, IMI Cornelius Inc.
I
M
A
CE
AKER
DAPTER
Table 1. Applicable Models
Table 2. Adapter Kit Parts
Ice Maker Adapter Lid
Bracket, Ice Maker Mounting
RTV, 3-Oz. Tube
Cover, Manual Ice Fill
#10 Sheet Metal Screw
Thumb Screw, #8-32X3/8-in. Long
Installation Instructions
www.cornelius.com
Ice Maker Adapter Kit P/N 629085001 Installation Instructions
K
(P/N 629085001)
IT
Wilshire WCC500/700
Name
- 1 -
Ice Maker Model
Qty.
12
Publication Number: 620913501
1
2
1
1
1
1
Revision: B