Protecting The Environment - DeWalt DCH911 Original Instructions Manual

English

WARNING: To ensure safe and efficient operation,
always keep the electrical appliance and the ventilation
slots clean.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non‑metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Ventilation slots can be cleaned using a dry, soft non‑metallic
brush and/or a suitable vacuum cleaner. Do not use water or
any cleaning solutions. Wear approved eye protection and an
approved dust mask.
Transport

CAUTION: Accidental starting during transport!
• Always transport your tool with removed battery or
disconnected power supply cord.
• Check the tool for damage before use after transport.
Storage
• Before storage, remove the battery from the tool or disconnect
the power supply cable from the mains.
• Clean the tool before storage. Refer to Cleaning.
• The storage place must be suitable for the weight of the tool.
• Store the tool in a cool and dry place.
• Store the tool in a place where they cannot be accessed by
children or unauthorized persons.
• Check the tool for damage before use after long periods
of storage.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
w
household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.
14
WALT‑recommended
e
Rechargeable Battery Pack
This long‑life battery pack must be recharged when it fails to
produce sufficient power on jobs that were easily done before. At the
end of its technical life, discard it with due care for our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
SDS plus® and SDS max® are registered trademarks of
Robert Bosch GmbH.