Gira 2320 Series Operating Instructions

Operating instructions
IP flush-mounted radio
2320 ..
Gira
Giersiepen GmbH & Co. KG
Elektro-Installations-
Systeme
Industriegebiet Mermbach
Dahlienstraße
42477 Radevormwald
Postfach 12 20
42461 Radevormwald
Deutschland
Tel +49(0)21 95 - 602-0
Fax +49(0)21 95 - 602-191
www.gira.de
info@gira.de
Safety
Electrical devices may only be
installed and connected by a
qualified electrician!
These instructions are an integral part of
the product and must remain with the end
customer.
Accessories
• Speaker for the IP flush-mounted radio
(Item no. 2282 ..)
Intended use
• Playback of internet radio stations via
connected speakers or speakers for
mobile devices, operation of a Sonos
music system
• Possible to operate and programme
using a mobile end device (smartphone
or tablet) via Bluetooth with the Gira
System 3000 app
• Installation in DIN 49073 device box
Device components
5
4
3
1 IP flush-mounted radio operating top unit
with display and operating surface
2 Speaker cover
3 Cover frame
4 Speaker insert
5 IP flush-mounted radio insert
1
Symbols on the display
The information shown on the display may
be different, depending on the settings in
the Gira System 3000 app.
1,2,3 Favourite station active
Bluetooth connection active
WLAN connection active
Sleep mode active
Alarm clock active
12:03 Time
Operating surface symbols
1, 2
+, -
Installation
Risk of death from electric shock.
Disconnect the device. Cover any live parts.
Selecting the installation location:
• Install indoors in an area protected
against dripping and splashing water.
• If there are any electronic devices (e.g.
ballasts) in the same installation unit or
in the immediate vicinity, test on site and
increase the spacing in the event of
malfunctions.
1
• Recommended installation height
approx. 1.5 m
Connecting speakers (optional)
The speaker impedance must not be less
than 4 ohms!
2
1. Insert the speaker insert and lay the
speaker insert connection cables in the
device box of the IP flush-mounted radio
insert
.
The support ring seal of the speaker insert
acoustically decouples the insert from the
front sound opening and improves the low-
frequency reproduction.
Do not remove the support ring seal and do
not damage it, except for piercing it with
the mounting screws.
2
2. Connect the speaker connection cables
to the IP flush-mounted radio insert.
For mono operation, connect the speaker
insert to the left channel (L+/L-).
Press briefly: next station (radio)
or track (Sonos, Bluetooth stream)
Press and hold: previous station or
track
Press briefly: call up favourite,
Sonos: 1-previous playlist, 2-next
playlist
Press and hold: save current
station as favourite
Press briefly: switch on or off or
set active alarm clock to snooze
mode
Press and hold: switch off
automatically after 30 minutes
(activate sleep mode) or switch off
active alarm clock when on,
activate alarm clock when off
Increase or decrease volume
DANGER!
Do not remove the support ring
seal for low-frequency
reproduction.
Terminal Connection cable
+ red
- black
Mono operation!