Download Print this page

B&G NMEA 2000 Installation Manual

Remote button

Advertisement

Quick Links

Disclaimer
This product is not a substitute for proper training and prudent seamanship. It is the owner's sole responsibility to install and use the equipment in
a manner that will not cause accidents, personal injury or property damage. The user of this product is solely responsible for observing maritime
safety practices.
Navigational features that appear in this guide are not a substitute for proper training and prudent seamanship. They do not replace a human
navigator and SHOULD NOT be relied on as a sole or primary source of navigation. It is the operator's sole responsibility to use more than one
navigational methods to ensure the route suggested by the system is safe.
NAVICO HOLDING AS AND ITS SUBSIDIARIES, BRANCHES AND AFFILIATES DISCLAIM ALL LIABILITY FOR ANY USE OF THIS PRODUCT IN A WAY THAT
MAY CAUSE ACCIDENTS, DAMAGE OR THAT MAY VIOLATE THE LAW.
This manual represents the product as at the time of printing. Navico Holding AS and its subsidiaries, branches and affiliates reserve the right to
make changes to the product and/or specifications at any time without notice. Please contact your nearest distributor if you require any further
assistance.
WARNING: Always wear appropriate eyewear, ear protection, and a dust mask when drilling, cutting, or sanding. Remember to check the reverse side
of all surfaces whenever drilling or cutting.
Compliance statements
Europe
NMEA 2000
remote button complies with CE under EMC Directive 2014/30/EU. The relevant Declaration of conformity is available in the product's
®
section at the following website: www.lowrance.com, www.simrad-yachting.com, www.bandg.com.
United Kingdom
NMEA 2000
remote button complies with UKCA under The Electromagnetic Compatibility Regulations 2016. The relevant Declaration of conformity
®
is available in the product's section at the following website: www.lowrance.com, www.simrad-yachting.com, www.bandg.com.
United States of America
WARNING: The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Australia and New Zealand
NMEA 2000
remote button complies with the requirements of level 2 devices of the Radiocommunications (Electromagnetic Compatibility)
®
standard 2017.
Trademarks
®
Reg. U.S. Pat. & Tm. Off, and ™ common law marks. Visit www.navico.com/intellectual-property to review the global trademark rights and
accreditations for Navico Holding AS and other entities.
Copyright
Copyright © 2022 Navico Holding AS.
Warranty
The warranty card is supplied as a separate document. In case of any queries, refer to the brand website of your unit or system:
www.lowrance.com, www.simrad-yachting.com, www.bandg.com.
NMEA 2000
REMOTE BUTTON
®
INSTALLATION GUIDE
Parts included
• NMEA 2000
remote button
®
• Micro-C connector (male)
• NMEA 2000
Micro-C T-connector
®
Scan for more info
www.bandg.com

Advertisement

loading

Summary of Contents for B&G NMEA 2000

  • Page 1 Warranty The warranty card is supplied as a separate document. In case of any queries, refer to the brand website of your unit or system: www.lowrance.com, www.simrad-yachting.com, www.bandg.com. Parts included • NMEA 2000 remote button ® • Micro-C connector (male) •...
  • Page 2 ® Waterproof rating IP67 Create Crew Overboard waypoint To create a Crew Overboard waypoint at the vessel’s location, press the NMEA 2000 remote button once. When pressed, ® Electrical the LED light around the button starts flashing. Pressing the remote button repeatedly creates multiple waypoints.