Related Manuals for MRMC Bloop Light
Summary of Contents for MRMC Bloop Light
- Page 1 Bloop Light Quick Start Guide QSG Product Code: MRMC-2174-01 Product Covered: MRMC-2132-01...
- Page 2 Bloop Light Quick Start Guide QSG Product Code: MRMC-2174-01 Date Modified: 4 August 2023 Product Covered: MRMC-2132-01 © 2022 Mark Roberts Motion Control Ltd. All rights reserved. No part of this publication may be reproduced, transmitted, or translated by any means — graphical, electronic, or mechanical — including...
-
Page 3: Table Of Contents
Intellectual property ............. 2 Overview ................. 2 Connecting the cables ............3 Configuration A: Connecting Directly to RT-14..3 Configuration B (using Triggers Box)......... 4 Testing Bloop Light ............5 Setting up Bloop Light in Flair ..........6 Cyclic Triggers............... 7... - Page 4 Bloop Light Quick Start Guide...
-
Page 5: Chapter 1 Quick Start
Chapter 1 Quick start Bloop Light Quick Start Guide Bloop Light Quick Start Guide Important safety instructions To ensure the best from the product, please read this manual carefully. Keep it in the safe place for future reference. To reduce the risk of electric shock, do not remove the cover from the unit. -
Page 6: Intellectual Property
Overview Thank you for using the Bloop Light from Mark Roberts Motion Control (MRMC). Bloop Light can be configured to flash on a pulse signal from Flair which allows the editor to sync picture with motion control data for simplified post production. In other words, bloop light can be used to set up timing accurately in the move. -
Page 7: Connecting The Cables
In Flair, the button for Trigger 1 is labelled Bloop by default unless you have changed it, as it is usually used to trigger the Bloop light. YYou can change this name in Flair by using the same menu options that you use to add triggers to a move: Setups >... -
Page 8: Configuration B (Using Triggers Box)
Triggers Box The External Camera Trigger Out and Sync In are directly connected to the camera. The Bloop light also has a direct connection. The Bloop light plug itself (black in the photograph) is wired for two inputs: If you plug the Bloop light into the BLOOP connector on the ribbon cable, you can trigger it with the Trigger 1 signal. -
Page 9: Testing Bloop Light
As in Configuration A above, in Flair, the button for Trigger 1 is labelled Bloop by default unless you have changed it, as it is usually used to trigger the Bloop light. See the Flair documentation for details. Testing Bloop Light... -
Page 10: Setting Up Bloop Light In Flair
Test button can be used to test the bloop light. When pressed the bloop light should activate and deactivate upon release. You can switch the bloop light on and off up to 15 times within the move. The frame count (fractional if desired) at which the bloop... -
Page 11: Cyclic Triggers
Setups > Output Triggers. Cyclic Triggers Bloop light flash can be set to repeat in a cycle throughout the move. Enter the On For value defining the duration of the trigger. Enter a Cycle Every value to specify the duration after which the bloop lights flashes. - Page 12 Bloop Light Quick Start Guide Notes...
- Page 13 Bloop Light Quick Start Guide Notes...
- Page 14 Bloop Light Quick Start Guide Notes...
- Page 15 Bloop Light Quick Start Guide Notes...
- Page 16 Mark Roberts Motion Control Ltd. Unit 3, South East Studios, Blindley Heath, Surrey RH7 6JP United Kingdom Telephone: +44 (0) 1342 838000 info@mrmoco.com www.mrmoco.com...
Need help?
Do you have a question about the Bloop Light and is the answer not in the manual?
Questions and answers