Cornelius Flavor Fusion 620701601 Installation Instructions

INSTALLATION INSTRUCTIONS

ED/DF300 30" CCM1530 N
This Nordic style kit applies to the Cornelius 30" Wide CCM1530 Nordic Ice Maker.
Item No. Part No.
1
620046139
2 620050521
3
620051215
5
50904
6
602701601
7
620204719 I N S
8
630500109
!
WARNING:
Disconnect power to the unit before installing the adaptor following all lockout/tag out procedures established by the
user. Verify that all the power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
!
WARNING:
All ice baffle plates and bin stats, if included or recommended in this kit, must be installed as directed in this manual or
the equipment manufacturer's instructions.
Failure to comply could result in serious injury, death or damage to the equipment.
!
WARNING:
All of the attachment screws and plates must be installed as directed in this manual.
Failure to comply could result in serious injury, death or damage to the equipment.
!
WARNING:
The dispenser must be secured with 3/8 X16 bolts (6) to the counter before installing the ice maker adapter kit. Refer
to the installation manual for the counter mounting template.
1. Position the ice maker adapter lid (item 1), flush with the rear of the cabinet, on the dispenser.
2. Seal the ice maker base to the adapter lid as follows:
A. Locate the ice maker two inches from the rear and flush with the sides of the lid. Run a bead of RTV
inside the perimeter of the ice maker base so that the base sets on the RTV.
B. Set the ice maker onto the lid. Note: if installing the ice maker from the front of the dispenser, use a
piece of 1" PVC pipe or larger as a "roller" to slide the ice maker over the front mounting bracket of the
manual fill cover.
C. Wipe away any excess RTV.
3. With the ice maker installed on top of the adapter lid, drill 0.147 diameter holes (#26 drill) into the dispenser cabi-
net using the slotted holes in the side flanges of the lid as templates. Be careful not to drill into the ice storage
hopper. Use of a drill stop (1/4 in.) is recommended. Secure the lid to the cabinet with (4) #10 sheet metal screws
(item 6).
Release Date: October 27, 2010
© 2007-2010, IMI Cornelius Inc.
ED/DF2XX 30" CCM1530 Nordic Style Lid Kit Installation Instructions
FOR
Table 1: Loose Shipped Parts
Ice Maker Adapter Lid
Manual Fill Cover
Ice Maker Mounting Bracket
RTV Sealant 3oz. Tube
#10 X 1/2" Sheet Metal Screw
Installation Instructions
Bin Stat
www.cornelius.com
SS S
ORDIC TYLE
Name
- 1 -
L K
ID IT
Qty.
1
1
2
1
8
1
1
Revision: B
Publication Number: 620204719INS