Table of Contents
Advertisement
For more information, please refer to
Assigning IP Addresses
At this time, the MV2 does not support static IP assignment. MV2 units must be added to a subnet that uses DHCP and has available DHCP addresses to
operate correctly.
Install Instructions
MV2 has a wide range of options for indoor installs. These include wall/ceiling mounting as well as leaving it on top of a flat-surface such as a table or a rack.
The camera out of the box comes with a protective lens cap. Do not remove this lens cover before installation is complete.
MV2 is an indoor only camera and should not be installed outside
Wireless Onboarding on MV2
5
Advertisement
Table of Contents
Need help?
Do you have a question about the MV2 and is the answer not in the manual?