Download Print this page
Rain Deck RD432-0 Owner's Manual

Rain Deck RD432-0 Owner's Manual

Chemical controller

Advertisement

Quick Links

RD432-0 CHEMICAL CONTROLLER
M720 pH/ORP Controller
ipscontrollers.com
pH
Dose
Alert
IPS-M720
Up
Down
MODE
pH
Owner's
Manual
ORP
mV
Set
Dose
Delay
Level
Time
Time
Auto
pH
ORP
Flow
ORP
AC Power
Dose
Alert
ORP
pH
pH
Cal
Flow

Advertisement

loading

Summary of Contents for Rain Deck RD432-0

  • Page 1 RD432-0 CHEMICAL CONTROLLER M720 pH/ORP Controller ipscontrollers.com Dose Dose Alert Alert IPS-M720 Dose Delay Down Level Time Time Auto Flow MODE AC Power Flow Owner’s Manual...
  • Page 2 Table of Contents...
  • Page 3 A. Water Chemistry...
  • Page 4: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL Risk of electric shock: — D...
  • Page 5 C. System Components...
  • Page 8 Enclosure: Note: Electrical Input/Output: pH Set Level: ORP Set Level: Dose Time: High Alert Low Alert Readout: Alarm:...
  • Page 9 ipscontrollers.com Dose Dose Alert Alert Flow Cell IPS-M720 Dose Delay Down Level Time Time Auto Flow MODE AC Power Flow Flow Switch Controller Communication digital display Electrical pushbutton LEDs Figure 2:...
  • Page 10 • • • •...
  • Page 11 b. 2 c. 3 d. 4 Note: Figure 3:...
  • Page 12 A. Setup B. Tools C. Procedure Note:...
  • Page 13 Note: Verify Note: We recommend that Note: Carefully unpack the pH and ORP sensors and set aside in a...
  • Page 15: Startup And Shutdown

    A. Startup and Shutdown Note: Water should pass over the pH and ORP sensors for a minimum of 10 minutes to allow for pool or spa. Note: Always cell.
  • Page 16: Modes And Adjustments

    Note: If pH level in the pool is at desired set level, and chlorine/bromine level is at desired PPM level in the pool, the ORP set level should be the the mode will cycle from Auto to pH Standby to ORP Standby, and then return to Auto mode.
  • Page 23 Figure 4: Note: Failure mode.
  • Page 24: Maintenance

    C. Maintenance Note: Do not touch or brush For commercial pools and spas:...
  • Page 26 Set level is too low: Chemical feeder is empty (base): Chemical tank is empty (acid): Set level is too low:...
  • Page 27 Chemical feeder is empty: 6. Chemical check valve/injector is clogged: ORP Set level is too high: Problem with chlorine supply: No power supply: No Flow:...
  • Page 28 Inadequate Flow Blown output fuse in the controller:...
  • Page 29: Warranty

    Warranty IPS-M720 pH/ORP Controllers Other Components Claims...