Sentera Controls DRPS8-24/40 Mounting And Operating Instructions

Din rail power supply module

Advertisement

Quick Links

DRPS8-24/40
DIN RAIL POWER
SUPPLY MODULE
Mounting and operating instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DRPS8-24/40 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sentera Controls DRPS8-24/40

  • Page 1 DRPS8-24/40 DIN RAIL POWER SUPPLY MODULE Mounting and operating instructions...
  • Page 2 DRPS8-24/40 DIN RAIL POWER SUPPLY MODULE Table of contents SAFETY AND PRECAUTIONS PRODUCT DESCRIPTION ARTICLE CODES INTENDED AREA OF USE TECHNICAL DATA STANDARDS WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS VERIFICATION OF INSTALLATION TRANSPORT AND STOCK KEEPING INFORMATION WARRANTY INFORMATION AND RESTRICTIONS...
  • Page 3 DRPS8-24/40 DIN RAIL POWER SUPPLY MODULE SAFETY AND PRECAUTIONS Read all the information, the datasheet, mounting and operating instructions and study the wiring and connection diagram before working with the product. For personal and equipment safety, and for optimum product performance, make sure you entirely understand the contents before installing, using, or maintaining this product.
  • Page 4 MODULE PRODUCT DESCRIPTION DRPS8-24/40 are 24 VDC / 40 W DIN rail mounted power supply modules with two RJ45 connectors and terminal blocks for output voltage connection. They are Power over Modbus compatible and have a wide supply voltage range.
  • Page 5 DRPS8-24/40 DIN RAIL POWER SUPPLY MODULE WIRING AND CONNECTIONS Terminal block Supply voltage, line: 85—264 VAC / 50—60 Hz Supply voltage, neutral: 85—264 VAC / 50—60 Hz 24 VDC Output voltage connection Output 1 Ground for output voltage connection 24 VDC...
  • Page 6 DRPS8-24/40 DIN RAIL POWER SUPPLY MODULE Fig. 3 Wiring diagram Supply voltage 85—264 VAC / 50—60 Hz Output 1 Output 2 RJ45 1&2 24 VDC / GND 24 VDC / GND Plug in the RJ45 sockets and / or use the terminal blocks for output voltage connection (see Example 1 and Example 2 below).
  • Page 7 DRPS8-24/40 DIN RAIL POWER SUPPLY MODULE VERIFICATION OF INSTALLATION After switching on the power supply, the green LED should be ON (see Fig. 4 Power OK indication). If this is not the case, check the connections. Fig. 4 Power OK indication...

Table of Contents