Chalmor CMD/REM2/V2 Product Manual

CMD/REM2/V2
Infrared Programming Handset
The CMD/REM2/V2 is a compact infrared handset used for the
basic programming of IR enabled Chalmor products.
Pointing the Handset
You must point the handset directly at the device that you want
to control or program .
When programming a device it is only necessary to point the
handset when 'sending' a new setting.
Sending settings to a device
To send the programming parameters to the device follow the
table on page 2. The shift key is used to access the parameters
in red and blue text. The Send LED flashes once to signify that a
setting has been sent.
Advanced settings
For advanced settings use the CMD/REM4/V2 handset.
Important note
This handset may include settings that are not used on the
device being programmed. Refer the individual device's Product
Guide for default and special settings.