Advertisement
2 - NUMBERING
Each transmitter is manufactured and sold with a different factory set
sequence number and facility code.
3 - PROGRAMMING
The transmitter facility code and sequence number must be
programmed into your system memory. Your own installer or reseller will
provide you the necessary instructions for your system.
4 - OPERATION
a. Firmly depress either button until the small red LED illuminates.
b. After the LED has illuminated, release the button. If the device you are
attempting to activate does not respond, repeat steps a. and b. or
consult section 6 (Troubleshooting) of this manual.
5 - BATTERY ACCESS
To access the battery turn the battery door
clockwise
. Place the 2 lithium CR2016 batteries
into their holder making sure they make contact
with the internal ring and with the positive (+) side
of the battery facing the back of the transmitter.
NOTE: Please dispose of the batteries properly
according to local laws and regulations.
Test proper battery installation by verifying that
the red LED illuminates when either button is
pushed.
6 - TROUBLESHOOTING
PROBLEM
The system does not receiver the
transmitter signal.
The transmitter LED will not light
The system does not receiver the
transmitter signal.
The transmitter LED is ON
The operating range is reduced
Back of
transmitter
SOLUTION
Replace the transmitter
batteries
Check to verify the
transmitter is programmed
into your system
Replace the transmitter
batteries
Transmitter Solutions - Type : 295SEPA2K
FCC ID : SU7295SEPA2K
This device complies with
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept interference received, including
interference that may cause undesired operation.
Any changes or modification to
approved by
Transmitter Solutions
WARRANTY
The warranty period of
Transmitter Solutions
beginning from the manufacturing date of the transmitter. During this period, if the
product does not operate correctly, due to a defective component, the product
will be repaired or replaced at the sole discretion of
The warranty does not extend to the transmitter case which can be damaged by
conditions outside the control of
Part. 15 of the
FCC Rules
Notice
Transmitter Solutions
equipment not expressly
could void the manufacturer's warranty.
295 transmitters is 60 months,
Transmitter Solutions.
Transmitter Solutions
or to battery life.
TRANSMITTER SOLUTIONS
7380 S. Eastern Ave, Ste 124-320
Las Vegas, NV 89123 -
(866) 975-0101 - (866) 975-0404 Fax
sales@transmittersolutions.com
Advertisement
