RapidLED R9996-S-BK Installation Instructions

These instructions should be read carefully and kept for future reference
TECHNICAL DATA
MODEL # TRIM COLOUR
R9996-S-BK Black
R9996-S-WH White
Class II construction
220-240V / 50~60Hz
INSTALLATION & WARNINGS
Read installation instructions carefully before installing.
This product may contain substances that can be hazardous to the environment if not disposed of properly.
Electrical and electronic equipment should never be disposed of with general household waste but must be
separated for its correct treatment and recovery. Where possible recycle your packaging.
It is recommended that luminaires are installed / maintained by a fully qualified electrician and wired in accordance to the latest IEC standards or national
equivalent.
Mains power must be switched off during any installation or maintenance.
Do not install the luminaire near any heat source.
Do not exceed the nominal supply voltage or amperage ratings.
Make sure the wires have been properly connected before powering on the device.
Non-user replaceable light source - when light sources reaches it's end of life, module must be replaced.
The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 0.3m is not expected.
Risk of fire - required clearance from structural members and building elements as stated below.
Do not use for high risk task area lighting.
Proof against supply voltage polarity reversal.
Reinforced insulation between the supply and the battery circuit.
Recharging device will recharge the battery normally after recharging device operated at 1,1 times rated supply voltage and the maximum of the declared ambient
temperature range with the batteries disconnected and replaced by a short circuit link.
WARRANTY
- This Rapid LED product is covered by a 5 Year warranty
( 2 Year replacement & labour / 3 Years replacement only )
- The battery in this product is covered by a 2 Year warranty
- Proof of purchase must be provided with all warranty claims
- All Rapid LED products must be installed by a licenced Electrical Contractor
- All Rapid LED products come with a warranty that cannot be excluded under the Australian Consumer Law
- Please contact Rapid LED on sales@rapidled.com.au for all warranty claims
TECHNICAL PARAMETERS
POWER
200-240VAC, 50/60Hz
SUPPLY
INPUT
35mA Max
CURRENT
OPERATION Maintained
FUNCTION Manual
POWER
>0.3
FACTOR
WORKING
0°C to +40°C
TEMPERATURE
OUTPUT
300mA
CURRENT CHARGE
CLASSIFICATION
C0 D1.25
C90 D2.0
INSTALLATION INSTRUCTIONS
CCT WATTAGE
6000k Max. 3w
6000k Max. 3w
CHARGE
DURATION
TEST
MODE
BATTERY
BATTERY
DISCHARGE CURRENT
BATTERY
VOLTAGE
EMERGENCY
DISCHARGE DURATION
OUTPUT
CHARGE VOLTAGE
LED EMERGENCY EXIT LIGHT
IP RATING
IP20
IP20
16H
Manual
LiFePO4 3.2V 600mAh
450mA
5.8V-7.15VDC
2H
5.8V-7.15VDC
RAPID BLADE
MOUNTING OPTIONS
Surface Mount
Surface Mount