Advertisement
Control Module Installation
1
Instalación del módulo de control
Installation de l'appareil de commande
• Select a location for mounting the Audio Module in a utility area or closet. The Audio Module has audio input jacks on the side of the module that
should be conveniently accessible to plug in additional audio inputs. Do not install any part of this assembly inside a wall. Secure to the wall with
screws.
• Make sure a 120 volt outlet is located near the module mounting location, 5 foot power cord is provided. Plug in the power cord after all connec-
tions are complete.
• Route the control cable from the module location to the 5GE-SMP Series generator. The manners in which the cables are routed are dependent
on what is best suited for the installation. There are multiple connection jacks in 5GE-SMP Series generator. (See figure 3 for the system wiring
diagram).
• Indicator lights, (See Figure 1):
Green Light: Power Light. This along with the blue and yellow light will flash momentarily when the power is first plugged in. This flash
indicates the microprocessor is functioning and is a test for the lights.
Yellow Light: Communication Light. This light is an indicator that the Audio system is not communicating with the control. After the
initial power up the light will continue to flash until communication is established with the 5CH-550, 5CB-550 or 5CN-550 series control. To
establish communication, power to the 5CH-550, 5CB-550 or 5CN-550 series control must be turned on or if power is already on go to the
5CH-550, 5CB-550 or 5CN-550 series control and start a steam or shower cycle for a few seconds then stop or cancel the cycle. This will
make the 5CN-550L look for the audio system and establish communication. When the Audio module is communicating with the
5CH-550, 5CB-550 or 5CN-550 series control this light will be off.
Blue Light: Bluetooth light. This light will be on steady when the bluetooth signal is broadcasting and not paired with a device. When it is
paired it will flash and when it is off, it means that bluetooth is turned off in the 5CH-550, 5CB-550 or 5CN-550 series control settings.
• Refer to the wiring diagram on (Figure 3) for connecting the speakers to the control module, ensuring the wall thickness is no greater than 7/8".
To reduce the risk of electric shock, do not perform any servicing other
than that contained in the operating instructions unless you are qualified
to do so.
Figure 1
Side View/Vista lateral/Vue latérale
Bluetooth antenna
Antena bluetooth
Antenne Bluetooth
Indicator lights
Luces indicadoras
Voyants
Yellow
Green
Blue
Speaker connections
Conexiones de altavoces
Connexions des haut-
parleurs
Power cord
Cable de alimentación
Cordon d'alimentation
CAUTION
!
Control cable connections
Conexiones para cables de
control
Connexions du câble de
l'appareil de commande
Audio "A" input
Entrada de audio "A"
Entrée audio « A »
Audio "B" input
Entrada de audio "B"
Entrée audio « B »
Right +/Derecha +/Droit +
Right -/Derecha -Droit -
Left -/Izquierda -/Gauche -
Left +/Izquierda +/Gauche +
2
113381 Rev. C
Advertisement
