Onn ONA11HO087 - Wireless Keyboard And Mouse With Nano Receiver Manual

Keyboard Button

To use this product properly, please read the user's guide before installation

1. LED Indicator
2. Connect Button
3. Battery Cover

Mouse Button

1. Left button
2. Right button
3. Scrolling Wheel
4. Backward
5. Forward

**
*Please insert the batteries with the correct position according to the instruction labeled in the Keyboard / Mouse.
*The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

Battery warning statement:
Do not mix old and new batteries
Do not mix alkaline, standard (carbon-zinc), or rechargeable Cni-cad, ni-mh, etc) batteries,

Setup the Connection between the Receiver and the Mouse, Keyboard

1. Plug the Nano receiver into the USB port of your computer.
2. Insert the batteries into the mouse and keyboard, then your mouse and keyboard will connect automatically.
3. If your wireless mouse and keyboard has not been connected to your computer after completing the previous steps, then put them into pairing mode.
4. Pairing: Press the connect button on the bottom of the mouse and keyboard, If the mouse or keyboard does not work after 10 seconds, Re-pair again, Keep the mouse and keyboard closer to the receiver while in pairing mode.
5. When the keyboard battery is low, the low power indicator will start to blink.

During pairing

	Red LED is on for 10 Sec. Power On
	Red LED Blinking for 10 Sec Low Battery Warning
	Red LED Blinking Pairing (LED OFF when paired or failed after 10 sec.)

	Red LED is on for 10 Sec. Power On
	Red LEO Blinking for 10 Sec. Low Battery Warning
	Red LED Blinking Pairing (LED OFF when paired or failed after 10 sec.)

Wal-Mart Stores, lnc.,
Bentonville, AR 72716
Hotline: 1-800-925-6278