Inserting The Batteries; Preparing The Remote Controller - Sherwood VD-4500 Operating Instructions Manual

Preparing the Remote Controller

Inserting the Batteries

Remove the battery compartment cover by
pressing the tab and lifting up the cover.
Insert the two batteries (size AAA/R3).
Be sure to match the + and – ends of the batteries with
the diagram inside the battery compartment.
Replace the battery compartment cover.
Notes
• Do not mix new batteries with old batteries or different
kinds of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
• Remove dead batteries immediately to avoid damage
from corrosion. If the remote controller does not
operate smoothly, replace both batteries at the same
time.
• The life of the batteries supplied is about six months
but this will vary depending on usage.
Using the Remote Controller
Point the remote controller toward the remote control
sensor.
Notes
• Place the unit away from strong light such as direct
sunlight or inverted fluorescent light which can prevent
proper operation of the remote controller.
• Using another remote controller of the same type in
the same room or using the unit near equipment which
uses infrared rays may cause operational interference.
• Do not put any object such as a book on the remote
controller. The buttons of the remote controller may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored
glass. Placing the unit behind such doors may prevent
proper remote controller operation.
• If there is any obstacle between the remote controller
and the remote control sensor, the remote controller
will not operate.
12