Zanussi ZWG 3162 User Manual page 67

Attention!
Before selecting Q " Drain" programme, or R "Spin"
programme the selector dial has to be positioned on
"O".
4 "Demi-charge/Halve belading" (Half
load) button
Select this button to reduce water consumption on
the rinse cycle when washing a half load of cottons
or linens (A-B-C-D-F).
5 "Départ/Pause / Start/Pauze"
(Start/Pause) button
After having selected the programme and the
required options press this button to start the
machine. The corresponding pilot light stops flashing
and remains lit.
To interrupt a programme which is running, depress
the Start/Pause button: the corresponding pilot light
starts to flash.
To restart the programme from the point at which it
was interrupted, press the START/PAUSE button
again.
6 Programme progress display
By selecting the wash programme, the pilot lights
corresponding to the various phases making up the
programme come on.
After the machine has started, only the running
phase pilot light stays on.
Prélavage/Lavage
Voorwassen/Wassen
Rinçage
Spoelen
Essorage
Zwieren
Vidange
Afpompen
Fin
Einde
Prélavage/Voorwas
●
Voorwassen/Wassen
on this means that the machine is performing the
prewashing/washing phase.
Rinçage+/Spoelen+:
●
on this means that the machine is performing the
rinse phase.
Essorage/Zwieren:
●
this means that the machine is performing the
spin phase.
Vidange/Afpompen:
●
on this means that the machine is performing the
drain phase.
: when this light comes
when this light comes
when this light comes on
when this light comes
Fin/Einde:
●
end of programme
The END (Fin/Einde) pilot light flashes in the event of
operating problems:
- 4 flashes = the door has not been closed
- 2 flashes = the machine does not empty
- 1 flash = the machine does not fill
To eliminate the problem, see paragraph "Something
not working".
7 Spin speed selector dial
This dial allows you to reduce the final and the
intermediate spin speeds or to select the NO SPIN
or RINSE HOLD (anti-crease)
The speeds on the dial refer to cotton programmes.
Position 1600 corresponds to 900 r.p.m. for
synthetics and wool/handwash and 700 r.p.m. for
delicates.
Position 700 corresponds to 450 r.p.m. for delicates
and 500 r.p.m. for synthetics and wool/handwash.
●
NO SPIN : by selecting this option all the
spinning phases are suppressed. To be used for
extremely delicate items.
The machine will add 3 rinses on cotton
programmes and 1 rinse on synthetic
programme.
●
RINSE HOLD (anti-crease)
option the water of the last rinse is not emptied
out to prevent the fabrics from creasing. When
the programme has finished the phase light END
is on to indicate that the water must be emptied
out. The door cannot be opened.
To do this:
●
turn the programme selector dial to "O"
●
select the drain Q
programme.
Using the spin speed selector dial you can
choose the desired spin. If the dial remains on
position Q or R the machine will perform the spin
speed at 400 rpm.
●
depress START/PAUSE button.
8 Programme selector dial
The selector is divided into 5 sections:
• Cotton
• Synthetic
• Delicate
• Wool
• Special programmes
O Reset programme/OFF
67
option.
: by selecting this
or spin R