Direct E-14 Instruction Manual

Spa circulation pump

E-10 & E-14 Spa Circulation Pump Instruction Manual

Resellers - Please ensure that the pump owner receives a copy of this manual

Warning

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or lack

of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a

person responsible for their safety.

Children should be supervised to ensure they do not play with the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order

to avoid a hazard.

When unpacking the unit, inspect carefully for any damage that may have occurred in transit. Check for loose, damaged or

missing parts. Any problem - contact either the supplier purchased through, or spatex immediately. Do not attempt to repair or

modify in any way or warranty may be void.

These pumps have been evaluated and authorised for water use only in spa / pool applications.

Ensure the power source is correct: 220v-240v, 50 / 60Hz

Maximum operating head pressure for E-10 & E-14 pumps - 2 bar.

Maximum water temperature - 60 degrees C.

Ensure installation is in a clean, dry, weather & humidity protected location with adequate air ventilation. Ensure the power cord

is run in such a way that any water that may get on it, cannot run down the cord to the motor. This unit cannot be submerged -

ensure it cannot flood.

Protect cords from sharp objects, hot surfaces; avoid kinking or coiling of the cord. Replace damaged cords immediately.

sales@directpoolsupplies.com.au

1800 648 363

Installation, Operation and Warranty

E-10 circulation pumps

E10-NSHNDNN2W-05

E-14 circulation pumps

E14-NSTNDNN2W-01

Table of Contents

Do you have a question about the E-14 and is the answer not in the manual?

Page 1 These pumps have been evaluated and authorised for water use only in spa / pool applications. Ensure the power source is correct: 220v-240v, 50 / 60Hz Maximum operating head pressure for E-10 & E-14 pumps - 2 bar. Maximum water temperature - 60 degrees C.
Page 2 Locate pump as close as possible to the fluid source thus making the suction line as short and direct as possible, using tubing on the suction that cannot collapse, such as a reinforced type. Support the tubing independently of the pump. Use clamps to secure and seal the tube to the pump.
Page 3 Warranty spatex warrants E-10 & E-14 (hereafter stated as the 'pump') shall be free from defects in materials & workmanship for a period of 18 months from date of supply to OEM/wholesaler/resellers or 12 months from date of purchase to the end user, whichever period ends first.
Page 4 cable gland. Alterations including power cord replacement not carried out by spatex that results in failure of the pump. Generally wet end failure is due to incorrect chemical care, dry running, use or installation and NOT warranted. Motor / electronics manufacturing defects resulting in pump failure ARE warranted where no wet end damage is evident. In the event of a wet end only failure, NOT covered by warranty, spatex at its discretion may supply repair components at nominal cost and will assess labour &...

E-10E10-nshndnn2w-05E14-nstndnn2w-01