F) Setting Ring For Torque; G) Led; Troubleshooting - Conrad 2524385 Operating Instructions Manual

f) Setting Ring for Torque

Turning the torque setting ring (2) permits setting of the desired torque from
which onwards the slip clutch will engage. This will prevent over-turning, e.g.
when turning in a screw. The screw will end flush with the material surface
when the torque setting is chosen accordingly.
The torque setting has 17 different positions and an additional position for the
drilling function (drill symbol, ideal for drilling holes).
Low setting: Soft materials, small screws
High setting: Hard materials, large screws
Drill symbol: Slip clutch off
When turning out screws, a higher setting or the "drill" setting (drill
symbol) should be chosen.

g) LED

When the on/off switch (8) is pushed, the LED (9) will be activated automatically
to permit lighting of the working position.

9. Troubleshooting

By purchasing this cordless screw driller, you have acquired a product designed to the state of the art and opera-
tionally reliable. Nevertheless, problems or errors may occur. The following contains descriptions for the removal of
possible interferences.
Always observe all safety information in these operating instructions!
Problem
No function.
The on/off switch cannot be
pushed.
Solution aid
• Is the rechargeable battery flat?
• Is the rechargeable battery properly inserted and latched?
• The on/off switch is blocked for reasons of safety when the
rotating direction switch is in the middle position.
Push the rotating direction switch out of the middle position.
A
B
33