Elicent FLUX Series Instruction Manual

Advertisement

TROUBLESHOOTING

PROBLEM
CAUSE AND REMEDY
The appliance does not switch on
There is no voltage.
Check the main switch and/or the electrical connections.
The impeller does not turn
Check that its movement is not slowed down.

DISMANTLING AND RECYCLING

The product has been designed and constructed using high-quality materials and components that can be
recycled or re-utilised.
If a crossed-out wheeled bin is illustrated on a product, this means that the product satisfies the require-
ments of the 2012/19/EU European Directive.
Make inquiries about the disposal collection methods of electrical and electronic products in force in the
zone in which the product must be disposed of.
Conform to the local norms regarding the disposal of waste materials and do not dispose of old products in
normal domestic waste material. A correct dismantling and disposal of products helps to prevent environ-
mental pollution and possible injury to health.
Abusive disposal of the product by the user implies the application of administrative fines foreseen by the
norms in force.
Maico Italia S.p.A.
Via Maestri del Lavoro, 12 - 25017 Lonato del Garda (Bs) ITALIA
Tel. (+39) 030 9913575 - Fax (+39) 030 9913766
e-mail: info@maico-italia.it
www.elicent.it
In case of incorrect or doubtful translation, only the Italian text applies (Translation of the original instructions).
The equipment must be installed only by a specialised technician!
Read and apply that referred to the following pages before carrying out the installation.
Keep this manual in a safe place.
Dear Customer,
the product you have purchased is a centrifugal duct fans range, designed to overcome the pressure and resistance
caused by long length of ducting, suitable for wall, panel and ceiling installation. o ensure optimum operation and guaran-
tee a long life, read this manual carefully that explains how to effectuate a correct installation and to use and maintain the
product properly. Following all the instructions ensures reliability and long life, both mechanically and electrically.
The manufacturer declines any responsibility for damages caused to persons or things deriving from the lack of
observance of the following described instructions.
The product is constructed using state of the art technology and respects the standards in force regarding electrical
equipment. It conforms with the EMC 2014/30/EU European Directive regarding radio interference suppression and elec-
tro-magnetic compatibility.

Installation and usage instructions

WARNING: Serious injury or death can be caused if these instructions are not ap-
plied!
• Do not use this product for uses that are different from those for which it has been designed.
• After removing the product from its packaging ensure that it is complete and undamaged; if in
doubt, immediately contact a qualified electrician.
• Do not leave parts of the packaging within reach of children or incompetent persons. To dispose
of the packaging and the appliance at the end of its useful life refer to the recycling norms in
force in your country.
• Immediately contact a qualified person (authorised dealer or the manufacturer) if the product is
dropped or knocked to check its correct functioning.
• Do not touch the appliance with wet or humid parts of the body (e.g., hands or feet).
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
• The means of disconnection from the supply mains must have a contact separation in all poles
and must provide full disconnection under overvoltage category III conditions.
• If there is a combustible-fed device (water heater, gas boiler, etc. of the sealed chamber type) in
the room where the product is to be installed check that the re-circulation of air is sufficient to en-
sure a good combustion for the correct functioning of these devices, precautions must be taken
to avoid the back-flow of gases into the room from the open flue of gas or other fuel-burning ap-
pliances.
• To avoid the risk of fire do not using the product in the presence of inflammable substances and
vapours, such as alcohol, insecticides, petrol, etc.
• The product can be connected to the supply mains only if the voltage and the frequency of the
supply mains correspond to those written in the rating label.
• In the case of malfunction, anomaly or any type of fault disconnect the appliance from the electri-
cal main supply and contact a qualified person. Use only original spare parts for repairs.
• The electrical system to which the appliance is connected must conform with the local norms in
force regarding electrical systems.
• The appliance must not be used to activate water heaters, room heaters, etc.
• It is forbidden for the appliance to discharge air into hot air ducts used for the evacuation of fu-
mes coming from the combustion of stoves or other combustion devices. It must discharge di-
rectly outside the building.
4/4
FLUX Series
ISTRUCTION MANUAL
1/4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FLUX Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Elicent FLUX Series

  • Page 1 In case of incorrect or doubtful translation, only the Italian text applies (Translation of the original instructions). TROUBLESHOOTING FLUX Series PROBLEM CAUSE AND REMEDY The appliance does not switch on There is no voltage. Check the main switch and/or the electrical connections.
  • Page 2 WARNING: Damage can be caused to the device if the following instructions are not when the fan is manually activated or in override mode. Pulling the cord again, the neon light is off and, after the overrun timer period, the fan reverts to the automatic operation by the humidistat to its stand-by position or, in case of a 2 speed applied! version at the minimum speed.

Table of Contents