Cobra 12 BAND XRS 9840 Operating Instructions Manual page 5

Installation
Your Detector
Windshield Mounting
1.
Attach the rubber
cups to the bracket.
2. Make sure the rubber cups and your windshield are clean.
3. Push the bracket firmly
onto the windshield.
4. Attach the detector to the
bracket. Check that the unit
is parallel to the road's
surface.
5. To adjust the angle if
necessary, gently push or
pull on the bracket to bend
it. DO NOT use the detector
to bend the bracket.
6. Plug the power cord
into the detector.
7. Plug the cigarette lighter
adapter on the power
cord into your vehicle's
cigarette lighter.
8. You can temporarily remove the detector whenever you
wish by depressing the bracket release button and sliding
it off the bracket.
4 English
Installation
Your Detector
Dashboard Mounting
1.
Place the detector on the dashboard to find a location
where the unit has a clear view of the road and is
parallel to the road's surface. The angle CANNOT be
adjusted after mounting.
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener.
You can remove and
reattach the unit as
often as you like.
5. Plug the power cord
into the detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle's
cigarette lighter.
Nothing Comes Close to a Cobra ® 5