3 Use your TV
Switching on your TV and putting it in
standby mode
TV
Remote control
Turns the tv on and off of standby.
Press B POWER on the TV or the remote control.
●
Note(s)
●
Energy consumption contributes to air and water pollution. When the AC
power cord is plugged in, your TV consumes energy with a very low standby
power consumption.
Adjusting volume
TV
Remote control
To decrease or increase volume
●
Press VOL + / – on the TV or the remote control.
VOL + : Volume up
VOL – : Volume down
To mute or unmute sound
Press 2 (MUTE) on the TV or the remote control to mute the sound.
●
Press 2 (MUTE) again or VOL + / – to recover the original sound.
●
Switching channels
TV
Remote control
To select channels by using CH + / –
●
Press CH + / – on the TV or the remote control.
To select channels by using the NUMBER buttons
Digital TV operation
●
For digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
When selecting digital channel 1 1. 1
–
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
When selecting cable or analog channel 1 1
–
Note(s)
●
To select the non-memorized channels, use the NUMBER buttons.
●
No signal will appear on the TV screen after the subchannel broadcast is
over.
18
.
English
Continued on next page.