Samsung WW90T684DLH/S1 User Manual page 64

Troubleshooting
Code
AddWash door is open
(applicable models only)
OC
LC, LC1
3C
3CP
UC
HC
1C
AC
8C
64 English
Untitled-5 64
This message appears when you open the AddWash door without tapping and
holding . If this happens, do one of the following:
• Press the AddWash door to close properly. Then, tap and hold
again.
• To add laundry, open the AddWash door and input laundry. Close the
AddWash door properly. Then, tap and hold
Water has overflowed.
• Restart after spinning.
• If the information code remains on the display, contact a local Samsung
service centre.
Check the drain hose.
• Make sure the end of the drain hose is not placed on the floor.
• Make sure the drain hose is not clogged.
• If the information code remains, contact a customer service centre.
Check the drum motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service centre.
The electronic control needs to be checked.
• Try restarting the cycle.
• If the information code remains, contact a customer service centre.
Check the pulsator motor for operation.
• Check if power is supplied properly.
• If the information code remains, contact a customer service centre.
Low voltage detected.
• Check if the power cord is plugged in.
• If the information code remains, contact a customer service centre.
High temperature heating check.
• If the information code remains, contact a customer service centre.
The Water Level sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
Check communications between main and sub PBAs.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
The MEMS sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service centre.
Action
to resume operation.
and try
2021-02-02 2:17:43