Glos LUCID Series Installation Manual

LUCID
SERIES

Important Notes and Satety Instructions

Please read installation manual carefully before commencement of installation.
Before carrying out any installation, ensure all power is switched off and disconnected from the main
power supply.
This product must be installed by a qualified installer under local and national regulations.
The light source of the luminaire is not replaceable. When the light source reaches its end of life, the
whole luminaire shall be replaced.

Product Warranty

For any warranty claim, a valid Proof of Purchase is required.
Glos does not warrant any claim based on defects or damage caused by improper
installation, improper operation, wrongful cleaning agents that deteriorate the surface
appearance, force majeure, and/or modifications made by purchaser or third party. For
warranty duration, please contact your service agent or GLOS sales representative for
more information.

Cleaning and Care

Before cleaning, disconnect the luminaire from main supply and allow it to cool. Clean
external surface using lint free cloth with alcohol-free and non-abrasive cleaning agent.

Corrosion Protection

Do not expose luminaire to corrosive agents (e.g salt, acid, chemical & cleaning agents)
during installation or cleaning, it will cause corrosion on the surface of the luminaire.

Ambient Condition

LED luminaires performs best in an ambient temperature <25°C (+-5°C). High ambient
temperature can reduce the lifespan and efficiency of LED module and driver.

Dimming

Before installation of luminaire, ensure control gear, LED and dimmer combination are
compatible. Improper or unsuitable use of dimmer can cause damage to the components.

Sizing Variation

D
A
B
C
Product A B C
LUCID 140 270 36
INSTALLATION MANUAL
D
146