Serious readers Clear Sun ROAM Light Instructions

Advertisement

Quick Links

Using Your ROAM Light™
1. Remove the light from the packaging and place flat on a
steady surface.
2. The power switch is a touch switch that controls both
on/off, and brightness settings.
Touch once to turn the light on to the 1st brightness
setting (least bright).
Touch a second time for the 2nd brightness setting
(mid-brightness).
Touch a third time for the 3rd brightness setting
(brightest).
Touch a fourth time to turn the light off.
3. To position the light, hold the light body steady and grasp
either the flexible neck or light shade, depending on the
adjustment needed.
4. The LED panel might get hot after several hours of
continuous use. Turn the light off and wait until the light
shade is cool before handling.
5. Do not alter the power adaptor.
6. Indoor use only.
7. The light shade is a sealed unit and cannot be replaced.

Battery and Charging

1. Charge your ROAM Light™ before use – it is shipped
uncharged.
2. Connect the USB-C charging cable to the power adaptor,
and into the power connector located at the rear of the
light body.
3. Only use with the supplied power adaptor to avoid
damage or fire.
4. Charge the light using the included USB-C charging cable
or power adaptor. It will take approximately 9.5 hours
to charge. The LED indicator on the rear of the light will
change from red to green when the light is fully charged.
Once fully charged, the battery will last approximately 3.5
hours on full brightness.
5. It is safe to use your ROAM Light™ while it is charging.

Battery Replacement

This light uses a lithium-ion battery. The battery
compartment is located on the rear of the light body.
To replace the battery, use a Phillips screwdriver to
remove the screw that holds the battery compartment
door in place. Remove the old battery and install a
new one with "+" facing upwards. Replace the battery
compartment door ensuring that the screw is tightened.

Battery Disposal

Batteries contain harmful materials, and are classified
as hazardous waste. They must never be thrown away
with daily rubbish. They should be returned to the
manufacturer or your local recycling service for disposal.
Do not incinerate.
Serious Readers® is WEEE registered and provides a
disposal service at Unit 15 – 16 Faraday Road, Aylesbury,
HP19 8RY.

Product Safety

If the battery compartment does not close securely, stop
using the product.
Avoid extreme temperatures.
Use original or certified cables. If the external flexible cable
or cord of this luminaire is damaged, it must be replaced
by the manufacturer in order to avoid a hazard.
Do not alter the plug.
Indoor use only.
Do not expose to liquids.
Avoid dropping.
Do not disassemble.
Keep new and used batteries away from children.

Specifications

Power: 5W LED
USB Charging Port: 1.0A
Lumens: 270
Input Power: 1.0A
Colour Rendering: Up to 97%
Colour Temperature: 5,000K
LED Lifespan: Up to 40,000
Power Adaptor:
hours
Input: 200-240V, 50/60 Hz.
0.25A Output: 5.0V DC
Height: 10.75" – 18.75"
(27 – 48cm)
Battery:
Lithium
Weight: 1.1lbs (500g)
3.7V/3350mAh/12.395Wh
Base Size: 2.6" x 3.6"
(6.5 x 9cm)
1
year
0800 028 1890
+44 (0) 1296 390390
www.seriousreaders.com
Serious Readers, Chapel of Light, Bierton,
Bucks, HP22 5DW, Great Britain
SR1220
ROAM
Light
Instructions
®
Readers

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Clear Sun ROAM Light and is the answer not in the manual?

Questions and answers

Summary of Contents for Serious readers Clear Sun ROAM Light

  • Page 1 4. The LED panel might get hot after several hours of continuous use. Turn the light off and wait until the light • Serious Readers® is WEEE registered and provides a shade is cool before handling. disposal service at Unit 15 – 16 Faraday Road, Aylesbury, HP19 8RY.
  • Page 2 Using Your ROAM Light™ Using Your ROAM Light™ What’s in the box? Changing the settings Charging the ROAM Light™ Changing the battery This light uses a lithium-ion battery. The Lightly touch the switch to change the light output settings: Connect the USB-C charging cable to the battery compartment is located on the rear of power adaptor and the light.

Table of Contents