FOR THE ELECTRICIAN
The electrical power to the unit is supplied
through the junction box at the rear of the
machine.
Check the nameplate (located on the back
panel) for the voltage requirements, and for
the minimum circuit ampacity. The machine
requires a solid chassis to earth ground wire.
The ice maker should be connected to its own
electrical circuit so it would be individually
fused.
POWER
SUPPLY
THIS UNIT MUST BE
GROUNDED
CONFORM TO ALL APPLICABLE CODES
Voltage variation must remain within design
limitations, even under starting conditions.
All external wiring must conform to
national, state, and local electrical codes.
The use of a licensed electrician is
required to perform the electrical
installation.
February, 1989
Page 7
NM1250
ICE MAKER
JUNCTION BOX