Scotsman FM2400RH Service Manual page 15

MAINTENANCE
////////////////////////////WARNING////////////////////////////
Disconnect electrical power before beginning.
/////////////////////////////////////////////////////////////////////////
1. The bin control uses devices that sense light,
therefore they must be kept clean enough so that
they can "see". At least twice a year, remove the
bin control sensors from the base of the ice chute,
and wipe the inside clean, as illustrated.
2. The ice machine senses water level by a probe
located in the water reservoir. At least twice a
year, the probe should be removed from the
RESERVOIR
CLEAN THE
WATER LEVEL
SENSOR
/////////////////////////////
CAUTION: THE
TIMP IS MADE OF
GLASS
///////////////////////////////
reservoir, and the tip wiped clean of mineral
buildup.
3. The bearing in the breaker should also be
checked at least two times per year.
Check the bearing by:
removing the ice chute cover
unscrewing the ice sweep
removing the water shed
using a spanner wrench and unscrewing the
breaker cover
unscrewing the auger stud
Inspect the assembly, looking for wear.
See Removal and Replacement to replace bearing
or seals. Reverse to reassemble.
SLIDE ICE
LEVEL
CONTROLS OUT
OF CHUTE
CLEAN THE ICE
LEVEL CONTROL
SENSORS
4. Check and tighten all bolts and screws.
SPANNER WRENCH
(only needed on
units mfg. before
1991)
August 1994
Page 15
FM2400RH
ICE SWEEP