Toto ALISEI THX118SX Quick Start Manual

SPECIFICATIONS
180
G½
OPERATING CONDITIONS
1.
Water supply pressure : 0.05 ~ 0.75 MPa.
Ensure that water supply is clean ( No Sand,
2.
Dirt, Etc.).
MAINTENANCE
All Finishes : Clean the finish with mild soap
and warm water. Wipe
completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which
could adversely affect the finish and are not
recommended for cleaning
S060417R
SPECIFICATIONS
180
G½
OPERATING CONDITIONS
1. Water supply pressure : 0.05 ~ 0.75 MPa.
Ensure that water supply is clean ( No Sand,
2.
Dirt, Etc.).
MAINTENANCE
All Finishes : Clean the finish with mild soap
and warm water. Wipe
completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which
could adversely affect the finish and are not
recommended for cleaning
S060417R
"ALISEI" HAND SHOWER SET
ATTENTION
1. Don t use abrasive cleaners or solvents on
faucets and fittings.
Flow Regulator should not be remove
2.
because it could damage the system
3.
As the product model is constantly updated,
the actual product may not look the same as
it shown in the diagram, but the basic
40
installation principles are the same.
PEMASANGAN
Packing
Flexible Hose
entire surface
"ALISEI" HAND SHOWER SET
ATTENTION
1. Don t use abrasive cleaners or solvents on
faucets and fittings.
Flow Regulator should not be remove
2.
because it could damage the system
3.
As the product model is constantly updated,
the actual product may not look the same as
it shown in the diagram, but the basic
40
installation principles are the same.
PEMASANGAN
Packing
Flexible Hose
entire surface
(3S MASSAGE)
Hand Shower
2 X Ø6.5
Holes
Slee ve
Anchor
Hange r
Packing
Screw
(3S MASSAGE)
Hand Shower
2 X Ø6.5
Holes
Slee ve
Anchor
Hange r
Packing
Screw
THX118SX
TROUBLESHOOTING
CHECK
PROBLEM
POINT
1
Unsatisfactory spray
2, 3
Water leaks around the nut
1. NOZZLES
Flow Regulator
Inside
3. NUT
(Don t remove)
2. NUT
THX118SX
TROUBLESHOOTING
CHECK
PROBLEM
POINT
1
Unsatisfactory spray
2, 3
Water leaks around the nut
1. NOZZLES
Flow Regulator
Inside
3. NUT
(Don t remove)
2. NUT
SOLUTION
Clean
Tighten
R1
SOLUTION
Clean
Tighten
R1