Scotsman CME306 Product Manual page 7

On a Bin
Unpacking and Assembly:
Begin with unpacking the ice storage bin. Remove
the carton, and using part of the carton as a
cushion, tip the bin on its back to remove the skid
and attach the legs or casters.
Return the bin to an upright position. Check the bin
top gasket for gaps and tears, fill any in with food
grade sealant prior to placing the ice machine on
the bin.
Level the top edge of the bin front to back and
left to right.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. After
removal of the shipping straps, lift the ice machine
off the skid directly onto the bin.
Note: The machine is heavy! Use a mechanical
hoist if necessary.
Secure the ice machine to the bin with the
hardware provided (two metal straps and 4 bolts).
Application Notes:
No thermostat is required for any of the following
bins.
BH375: Direct fit. Connect ice machine to bin
using strap and bolts from ice machine for the ice
machine side, and sheet metal screws to attach
the bracket to the bin. Use the bracket as a
template and drill two holes in the back of the bin
for the sheet metal screws.
HTB555: Use KBT27
BH550: Use KBT27 and Kbaffle1
Other Brand's Bins: KBT27 may allow installation
of this unit on a non-Scotsman 30" wide bin.
Thermostat kit KSTAT-22 must be used if the bin's
baffle is too short.
May 2004
Page 7
CME306 & CME456