Remove the fan
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 26
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Disconnect the fan cable from the system board. Release the cables from the cable guide.
Figure 16. Disconnect the fan cable from the system board
Step 3.
Remove five screws and then remove the fan.
Figure 17. Remove five screws and remove the fan
Screw specifications
M2 x L3.5
34
Hardware Maintenance Manual
Number of screws
5