Page 1
INSTRUCTIONS FOR USE by Colombini ANGEL.ST.18 ANGEL.ST.22 ANGEL.RT.18 ANGEL.RT.22 Read the instructions carefully Translations of the original instructions Edition EN-01 - January 2020 www.absoluteaftersales.it...
This manual is to be considered an integral part of the machine and must accompany it until it is destroyed. If it gets lost or damaged contact COLOMBINI for a replacement copy. The technical information contained in this manual is the property of COLOMBINI and must be considered confidential.
Page 3
Index General Information ......... 4 1.1. Machine components ......... 4 1.2. Manufacturer’s information ......4 1.3. Messages used ......... 4 1.4. Intended uses .......... 4 1.5. Required ambient conditions ..... 4 1.6. Noise level ..........4 1.7. CE marking plate ........4 1.8.
The warranty provided by COLOMBINI Srl is intended limited to what is stated in this article, and that is without any other liability for COLOMBINI Srl nor the Customer’s right to any compensation for damages. The measurements, weights, illustrations and draw-...
COLOMBINI Srl cannot be held liable in any case for accidents or damages consequent to using the ma- chine by personnel that is not adequately instructed...
If one or more of the components is damaged it is indispensable to stop the installation and report the fault found to the company COLOMBINI Srl making arrangements with the same on the actions to take. 3.1. Positioning Position the machine on a flat, horizontal and stable surface able to sustain the machine weight.
2) Maintenance key This will flash after 1000 hours of work (Please contact Colombini technical service centre) 3) Battery charge indicator This will flash when the battery is flat (replace the battery). See chapter 4.2. Battery replacement...
Remove the display panel (2) and disconnect the connector (B). Notes The patented Colombini grinders have a duration that can vary from 50 tonnes to 100 tonnes of prod- uct (roasted coffee beans). This figure varies based on the degree of coffee roasting and according to the type of grain size selected for the grinding.
Page 10
If it is necessary to intervene to replace parts subject to wear such as the discs, electric components, the belt or other it is necessary to refer to this exploded drawing reporting the following data to Colombini: - type of grinder - serial number...
Page 11
COLOMBINI Srl Via De Francisco 130/16 - 10036 SETTIMO TORINESE (TO) - ITALY Tel. 011.8211407 - Fax 011.8958221 E-mail: info@colombini.srl...