Device Parameter Configuration Interface; Screen Sleep - Ebyte ME31-AXXX8000 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd
3. Data bits;
4. Check digit;
5. Stop bit;
6. Local port
7. Local IP address
8. Network mode
9. Gateway
10. Subnet mask
11. DNS
12. MAC address
13. DHCP
14. Target IP
15. Target port
16. Modbus TCP/RTU protocol conversion
17. Active upload
18. Modbus address filtering

4.5.3 Device parameter configuration interface

Long press the confirm button to enter the password input interface, complete the correct password input, and
enter the configuration interface (password interface: default password: 0000; short press the middle to verify the
password, left and right buttons to switch password bits, up and down buttons to switch current bit values, a total of
4 digits of password, with each digit entering a range of 0-9 numbers).
Select the setting option, enter the parameter configuration page, and briefly press the up and down keys to
switch between the setting options;
Select the setting item, short press to confirm or right-click, and the cursor for the setting item represents the
selected item and enters the setting item;
Adjust parameter values: After selecting the setting option, the up and down keys can change the numerical
value or optional values; Press the left and right buttons to move the cursor within the parameter item;
Confirm parameter values: After adjusting the parameter values, press the confirm button to exit the current
setting.
Save parameter settings and restart: After setting the parameters, move the cursor to save and restart, then
short press the confirm button to enter the confirm save and restart state. Short press the confirm button (press other
buttons to exit the confirmation state) to save the parameters and restart the device.
Exit without saving parameters: move the cursor to Exit, and then press the OK key briefly to enter the
confirmed Exit status. Press the OK key briefly (press other keys to exit the confirmed status) to exit the parameter
configuration interface without saving parameters.
Among them, the data bits and stop bits cannot be set. After enabling DHCP mode, the local IP address,
gateway, and subnet mask cannot be configured and only assigned by the router;

4.5.4 Screen sleep

The device screen has a sleep function, which is turned off by default and can be set to turn on in the configuration
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd
15
ME31-AXXX8000_UserManual_CN