Makita DMC300 Instruction Manual page 13

3. Raise the tool handle slightly and place the front
half of the wheel guard at an angle into the dust col-
lection cover, throwing the bottom of the cutting wheel
down through the wheel slot in the base.
2
3
Fig.19 4
► 1. Wheel guard 2. Dust collection cover 3. Cutting
wheel 4. Wheel slot
4. Install the rear half of the wheel guard in the dust
collection cover, while lowering the tool handle from a
raised position to a down position.
1
2
Fig.20
► 1. Wheel guard 2. Dust collection cover
1
5. Raise the tool handle again to hook the rear edge
of the wheel guard over the stopper inside the dust
collection cover.
2
Fig.21
► 1. Wheel guard 2. Stopper
6.
Loosen the thumb screw. Swing the tool up and
down at your desired cutting depth. Then tighten the
thumb screw to secure the tool in place.
Removing dust collection cover
1. Loosen the thumb screw on the depth scale of the
dust collection cover. Lift the tool handle fully up, and
then tighten the thumb screw to secure the dust collec-
tion cover in a raised position.
3
Fig.22
► 1. Thumb screw 2. Depth scale 3. Dust collection
cover
13 ENGLISH
1
1
2