Hints And Tips - Zanussi ZDH87A2DG User Manual

3. Press the Start/Pause touch button.
The display shows the countdown of the delay
start.
When the countdown is completed, the programme
starts.
CHANGE A PROGRAMME
1. Press the on/off button to deactivate appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
Alternatively:
1. Rotate the selector knob to the
position.
2. Wait for 1 second. The display shows
.
3. Set the programme.
AT THE END OF THE PROGRAMME
When the programme is completed:
• An intermittent acoustic signal operates.
• The display shows
• The indicators
• The Start/Pause indicator is on.
The appliance continues to operate with the anti-
crease phase for approximately 30 minutes or more
if Long Anticrease option was set (see chapter
Option - Long Anticrease ).
The anti-crease phase reduces creasing.
You can remove the laundry before the anti-crease
phase is completed. We recommend, for better

HINTS AND TIPS

PREPARING THE LAUNDRY
Very often the clothes after washing
cycle are kneaded and tangled
altogether.
Drying kneaded and tangled clothes is
inefficient.
To assure proper air flow and even
drying it is recommended to shake and
load one by one the clothes to the
tumble dryer.
To assure proper drying process:
• Close the zips.
• Close the fasteners of duvet covers.
• Do not dry ties or ribbons loose (e.g. apron
ribbons). Tie them before you start a
programme.
• Remove all items from pockets.
14
"Reset"
Filter and Tank comes on.
results, that you remove the laundry when the
phase is almost completed or completed.
When the anti-crease phase is completed:
• The display still shows
• The indicators
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying results:
• Inadequate default dryness level settings. See
chapter Adjustment of default dryness level
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
Always clean the filter and empty
the water container when a
programme is completed.
STAND-BY FUNCTION
To reduce energy consumption, this function
automatically deactivates the appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the programme.
The time is reduced to 30 seconds if
the selector knob is pointing to
"Reset" position.
• Turn items with the internal layer made of cotton
inside out. Cotton layer must be faced
outwards.
• Always set the programme suitable for the type
of laundry.
• Do not put light and dark colours together.
• Use suitable programme for cottons, jersey and
knitwear to reduce shrinkage.
• Do not exceed the maximum load stated in the
programmes chapter or shown on the display.
• Dry only the laundry that is suitable for tumble
drying. Refer to the fabric label on the items.
• Do not dry large and small items together. Small
items can be trapped inside the large items and
remain wet.
• Shake the large clothes, fabrics before placing
in the tumble dryer. It is to avoid moist places
inside the fabric after the drying cycle.
Filter and Tank comes on.