Selecting The Heat Mode - Samsung MWR-SH00 User Manual

Selecting the Heat Mode

The Heat mode can be selected only on the heat pump models.
8
E-
Select the Heat mode to raise the room temperature.
1
Press the (ON/OFF) button to turn on the indoor unit.
(Do not press the
control is on).
Result: The air conditioner will be turned on with the
mode selected when the unit was last used.
Caution
The air conditioner has a built-in protection
mechanism to prevent the unit from being
damaged when it is started immediately after
being:
Plugged in
Stopped
The air conditioner will start up after 3 minutes.
2 To select the Heat mode, press the
is displayed on the remote control.
Result: The air conditioner will run in Heat mode.
3 To adjust the temperature, press the
set the desired temperature.
Result: The temperature is adjusted by 1°C(1°F) when
the
The air conditioner will start heating if
the temperature set is higher than the room
temperature.
The fan will run even if the temperature set
is lower than the room temperature.
4 To adjust the fan speed, refer to page 11.
Note
The Cool and Heat mode cannot be selected at
the same time.
(ON/OFF) button if the remote
button until
buttons are pressed.
buttons to