Advertisement
3
INSTALL THE LENS. (See figure-4)
Remove protective caps(front and
1.
back) on the lens.
Mount the lens on mounting bracket of
2.
the main cabinet with 4 screws.
Use the screws included with the lens.
Use the driver included with the lens
to fasten the screws.
(After using, save it for latter use.)
4
INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)
Install the light-block sheet around the lens as shown in the illustration.
Use the sheet included with the lens.
When this projector permanently install in the
structure, slide the picture, obtain correct
focus, then lock the lens by Focus Lens Lock
screw at this step.
5
MOUNT THE LENS COVER. (See figure-6)
When in install the both upper and lower lens
covers, install the light-block sheet so that it
should be placed in the guide slot. (the place
the covers had been placed. See figure-2.). If
the installation of light-block sheet is incor-
rect, it will be the cause of leakage of light or
the dust entering at the main cabinet.
Insert the upper part lens cover and
1.
fix them with screws A (4 screws).
Insert the lower part lens cover and
2.
fix them with screws B. (2 screws).
ATTACHED DRIVER
Adjust focus by rotating
the lens.
LENS MOUNTING BRACKET
FOCUS LENS LOCK SCREW
LIGHT-BLOCK SHEET
UPPER LENS COVER
A
B
LOWER LENS COVER
Fig-4
Fig-5
A
Fig-6
Advertisement
